Micros Systems 3700 POS Manual do Utilizador Página 275

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 314
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 274
3700 User’s A-25
Prompts and Messages
List of Prompts and Messages
You press a function key (e.g., [Sign In], [Pickup Check],
etc.) that should be preceded by letter or number entries and
was not.
An NLU screen is displayed and you press [Enter] without
first typing a number.
Entry too large
This message displays in response to one of the following:
You try to post an open percentage service charge greater
than 100%. Press [Clear] to continue.
You enter a check number with a [Begin Check By Number]
key and the number is outside of the specified range of
revenue center check numbers. For example, if the check
number range is 100–300 and you enter 425, this message
displays. Press [Clear] and enter a valid check number.
Entry too small
This message displays if you enter a check number with a
[Begin Check By Number] key and the number is outside of the
specified range of revenue center check numbers. For example,
if the check number range is 100–300 and you enter 15, this
message displays. Press [Clear] and enter a valid check number.
Error <-###> issuing request
This message displays if there is an internal error with the
credit card server. Write down the error number <-###> and
contact your support representative. You can perform a manual
authorization for the current check.
Error: check modem
This message displays during any type of credit authorization if
the modem is turned off or disconnected. Check the modem,
then try again.
Error connecting to autosequence PC
This message displays if the UWS on which you are running an
autosequence cannot communicate with the PC in this system
on which the autosequence server is running. Try again, then
contact your support representative.
Vista de página 274
1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 313 314

Comentários a estes Manuais

Sem comentários